B1GI0MK1 - 307 EW10J4 ENGINE

DRAINING - FILLING - BLEEDING COOLING SYSTEM

1 - SPECIAL TOOLS

[1] filling cylinder (-).0173-2 .

[2] Pliers (-).0165 .

2 - DRAINING

WARNING : the draining operation is carried out when cold .

Remove the cap from the expansion tank .

Open the bleed screws (1) .

NOTE : fit a pipe to the outlet to allow clean drainage of the system .

Disconnect the lower hose (2) from the radiator (use the tool [2]) .

Drain the engine by removing the plug (3) .

Close the bleed screws .

3 - FILLING AND BLEEDING THE SYSTEM

Before any re-filling operation, flush the cooling circuit with clean water .

WARNING : check the cooling system for leaks .

Fit the filling cylinder [1] to the filler opening .

Open the bleed screws .

Fill the circuit slowly with coolant .

Close the bleed screws when the liquid flows without bubbles .

The filling cylinder must be filled to the 1 litre mark to bleed the heater matrix correctly .

Start the engine .

Maintain a speed between 1500 and 2000 rpm until the end of the second cooling cycle (the cooling fan(s) cutting in then stopping) while keeping the filling cylinder full to the 1 litre mark .

Stop the engine .

Remove the filling cylinder [1] .

Immediately tighten the plug on the expansion chamber .

If necessary fill up to the level of the maximum mark ; Engine cold .