B2BG15K1 - 307 MA GEARBOX
REMOVAL - REFITTING CLUTCH
1 - SPECIAL TOOLS
[1] Clutch plate centralising mandrel (-).0213 .
2 - REMOVAL
Remove :
NOTE : mark the relative positions of the clutch and flywheel (in case of re-use of the cover) .
Check :
Rectify (if necessary) .
3 - REFITTING
Fit :
Tightening torque : 1.5 da.Nm .
Apply a fine coat of MOLYKOTE BR2 PLUS to the clutch stop guide .
NOTE : do not grease the input shaft splines .
Position the clutch release bearing .
refit the gearbox .