B2CG76K1 - 307 AL4 AUTOMATIC GEARBOX
REMOVAL - REFITTING AUTOMATIC GEARBOX INPUT SPEED SENSOR (AL4)
1 -
REMOVAL
NOTE :
do not drain the gearbox
.
Disconnect the battery
.
Remove
:
-
the ECU cover
-
the connector of the engine ecu
-
the air cleaner housing
-
the air hose
-
the battery
-
the battery container
Remove the 2 bolts (1) (Mounting of the modular connector on the gearbox)
.
Disconnect the modular connector (2)
.
Extract the 3-way connector (4) from the modular connector (2)
.
NOTE :
gearbox input speed sensor
.
Remove
:
-
the front left-hand wheel
-
the sensor harness (5)
-
the bolt (6)
-
gearbox input speed sensor (5)
2 -
REFITTING
Replace the sensor o ring (5)
.
Fit
:
-
gearbox input speed sensor (5)
-
the bolt (6) (tightening torque 1 da.Nm)
-
the sensor harness (5)
-
the yellow 3-way connector (4) in the modular connector (2)
-
the 2 bolts (1) (tightening torque 1 da.Nm)
Reconnect the modular connector (2)
.
Fit
:
-
the front left-hand wheel
-
the battery container
-
the battery
-
the air cleaner housing
-
the air hose
-
the connector of the engine ecu
-
the ECU cover
Connect the battery
.