B2CG82K1 - 307 AL4 AUTOMATIC GEARBOX
REMOVAL - REFITTING AUTOMATIC GEARBOX OIL PRESSURE SENSOR
1 -
REMOVAL
NOTE :
do not drain the gearbox
.
Remove
:
-
the ECU cover
-
the connector of the engine ecu
-
the battery
-
the battery container
-
the air cleaner housing
-
the air hose
Remove the 2 bolts (1) (Mounting of the modular connector on the gearbox)
.
Disconnect the modular connector (2)
.
Extract the green 3-way connector (3) from the modular connector (2)
.
Remove
:
-
the front left-hand wheel
-
the front left mud shield
-
the oil pressure sensor harness (4)
-
the 2 oil pressure sensor (4) fixing bolts
-
(4) automatic gearbox oil pressure sensor
2 -
REFITTING
Replace the sensor o ring (4)
.
Fit
:
-
(4) automatic gearbox oil pressure sensor
-
the 2 oil pressure sensor (4) fixing bolts : tightening torque 1 da.Nm
-
the oil pressure sensor harness (4)
-
the green 3-way connector (3) in the modular connector (2)
-
the 2 bolts (1) : tightening torque 1 da.Nm
Reconnect the modular connector (2)
.
Fit
:
-
the battery container
-
the battery
-
the air cleaner housing
-
the air hose
-
the front left mud shield
-
the front left-hand wheel
-
the connector of the engine ecu
-
the ECU cover
Connect the battery
.