C4AG0XF1 - 307

REMOVAL - REFITTING FRONT WING

1 - REMOVAL

Open the bonnet .

Remove the fixings (1) turning them a quarter turn each .

WARNING : use a 30 mm torx bolt to avoid damaging the quarter turn fixings recesses .

Open the door .

Remove the fasteners (2) .

Unclip the front wing at (A) .

Remove :

• the fasteners (3)
• the retaining clip (4)

Unclip the front wing at (B) (Take care not to break the fixings) .

Disconnect the wing repeater connector .

Remove the wing taking care not to break the canister locating pin (Front RH wing : Only) .

2 - REFITTING

IMPERATIVE : when refitting the wing, place the canister locating pin (5) in its location taking care not to break it (front RH wing : only) .

Reconnect the wing repeater connector .

Place the wing in position on the body .

Clip, then refit the upper fixing : A post side .

Refit the quarter turn fixings (1) .

Clip, then refit the lower fixing : A post side .

Refit the central fixing : A post side .

Reclip the wing at (B) .

Fit :

• the fasteners (3)
• the retaining clip (4)