C4BG1EF1 - 307

REMOVAL - REFITTING REAR SCREEN WIPER MOTOR

1 - REMOVAL

Release the cover (1) .

Remove :

• the nut (2)
• the wiper arm (3) ; USING THE TOOL [8]
• THE TAILGATE LOWER TRIM

Disconnect the connector (4) .

WARNING : for this operation, wear protective goggles .

Drill out the rivets (5) using a 7,5 mm drill bit .

IMPERATIVE : when removing the rivets, protect the rear screen and the tailgate ; limit the depth of drilling to 15 mm ; localise the falling of the rivets by placing cloths each side of the motor support in the tailgate .

Remove the rear windscreen wiper motor (6) .

2 - REFITTING

Proceed in the reverse order to removal .

IMPERATIVE : recover the rivets which fall into the tailgate to prevent noise ; remove the cloths .

NOTE : before fitting the wiper arm, operate the windscreen wiper, place the COM 2000 in the off position and position the arm correctly on the marks on the rear screen .

Tighten the fastener (2) to 1.2 daN.m. .