C4BH3BF1 - 307 5 DOOR SALOON

REPLACEMENT REAR WING INNER PANEL ASSEMBLY

IMPERATIVE : THIS VEHICLE HAS BEEN DESIGNED USING THE MIG BRAZING PROCESS TECHNIQUE ; when the structure is repaired, all the connections concerned must be welded using the same procedure ; any other technique is prohibited .

WARNING : all the scoured areas must be protected by the approved electrolytic re-zincing process .

IMPERATIVE : observe elementary health and safety rules (wearing of filter mask for organic fumes - work in a ventilated area) .

1 - COMPLEMENTARY OPERATION(S)

Replacement :

• REAR WING ASSEMBLY
• "D" POST

2 - IDENTIFICATION OF REPLACEMENT PARTS

(1) Rear wing inner panel assembly .

(2) Load floor extension .

3 - REPLACEMENT PART COMPOSITION

(2) Load floor extension .

(3) Tailgate drip moulding lining .

(4) Side panel vertical stiffener .

(5) Rear quarter panel inner panel .

(6) Lower quarter panel inner panel .

(7) Rear lifting stiffener .

(8) Rear wing inner panel .

(9) Rear wing inner panel front closer .

(10) Rear wing horizontal stiffener .

(11) Rear wing inner panel extension .

(12) Fuel pipe lower support .

(13) Rear shock absorber bracket .

(14) Floor/rear wheel arch connection .

(15) Rear wheel arch .

(16) Upper quarter panel inner panel .

(17) Roof arch insert .

4 - PART(S) REQUIRED TO CARRY OUT THE OPERATION

(1) Rear wing inner panel assembly .

(2) Load floor extension .

5 - PREPARATION OF NEW PARTS

6 - CUTTING OUT

7 - RELEASING

8 - ADJUSTMENT

9 - WELDING

10 - SEALING

11 - PROTECTION