C4CG2HF1 - 307
REMOVAL - REFITTING FRONT DOOR ELECTRIC WINDOW MECHANISM
1 - REMOVAL
Lower the glass approximately two thirds of its travel .
Detach the sealing sheet at the top and at the bottom .
Remove the 2 window fixings .
Raise the window and retain it in the high position with adhesive tape .
Place the electric window mechanism at the lowest limit .
Remove the motor from the electric window mechanism .
Disconnect the electric window motor connectors .
Knock in the rivet heads before drilling .
Using a 10 mm drill bit, drill out the rivets (A) .
When removing the rivets, protect the door panel .
Unclip the electric window mechanism at (B) .
Detach the electric window mechanism towards (C) and pull it towards the interior .
Remove the window mechanism via the opening (D) .
Drill out the rivet shanks remaining on the window winder mechanism .
Vacuum the bottom of the door to extract the remains of the rivets .
2 - REFITTING
IMPERATIVE : fit new seals, which must be assembled without folds and tears ; perfect cleanness is required on the door inner panel ; run a wheel over the parts of the flange to be bonded ; these recommendations are essential to prevent possible entry of water, dust or noise .
Proceed in the reverse order to removal .
Check the operation .