C4CG2LF1 - 307 5 DOOR SALOON

REMOVAL - REFITTING REAR DOOR OPENING MECHANISM

1 - REMOVAL

REMOVE THE REAR DOOR TRIM PANEL .

Raise the glass .

Detach the sealing sheet at the top .


Remove the interior opening control (1) .

Unclip the rod (2) .

Remove :

Disconnect the connector from the door opening mechanism .

2 - REFITTING

IMPERATIVE : fit new seals, which must be assembled without folds and tears ; the bearing surface on the interior panel needs to absolutely clean ; run a wheel over the parts of the flange to be bonded ; these recommendations are essential to prevent possible entry of water, dust or noise .

Proceed in the reverse order to removal .

REFIT THE DOOR TRIM PANEL .

Check the operation .