C4CH2AF1 - 307 5 DOOR SALOON

REPLACEMENT REAR DOOR

1 - TOOLING

[1] Door stand CELETTE .

Set of shims (-).1355-C :

• [2] 3 shims
• [3] 1 shim
• [4] 2 shims

2 - PARTS REQUIRED

(1) Hinge .

(2) Screw front pillar side .

(3) Screw door side .

(4) Shaft .

(5) Centralising pins .

(6) Clip .

3 - FITTING

Place the door on the stand [1] .

Position :

• the blocks [2] at (A) ; dimension of 16 mm towards the outside
• the shim [3] at (B) ; dimension of 14 mm towards the outside
• the [4] blocks 5 mm thick at (C)

Fit the hinges (1) on the centre pillar .

Half-tighten the bolts (2) .

Position the door opposite the hinges .

Half-tighten the bolts (3) .

Tighten the check strap on the centre pillar .

NOTE : the heads of the door pins (4) are facing each other .

Detach the tool [1] .

3 - 1 - CLEARANCE CHECK

Close the door .

CHECK THE FITS AND CLEARANCES .

Open the front door .

Tighten the fastenings (2) - (3) .

CHECK THE FITS AND CLEARANCES .

Tighten :

• the fastenings (2) to 6 da.Nm
• the fastenings (3) to 3 da.Nm