C5EG0XF1 - 307

REMOVAL - REFITTING JETS/HEADLAMP WASH ASSEMBLY

1 - TOOLING

[1] Immobilisation fork (-).1349-D .

2 - REMOVAL

Using a plastic spatula detach the jet trim (1) from the bumper skin .

Take hold of the trim and pull it towards you to position the fork [1] in the strut groove, then release it gently .

Using adhesive tape, protect the bumper scalloping .

Pull out the actuator using pliers .

Using another pair of pliers, tighten the 2 clips (2) pulling the jets assembly (1) to unclip it .

Remove the jets assembly (1) and release the strut (3) .

3 - REFITTING

Remove the adhesive tape .

Clip the jets assembly on the actuator .

Pull the jets assembly to check that it is clipped correctly and to remove the fork [1] .

IMPERATIVE : follow through the jets assembly return movement to the bumper (the return of the actuator may be very rapid and may damage the actuator or the bumper) .

Proceed in the reverse order to removal .

Check the operation .