C5GH0YF1 - 307

REPLACEMENT FRONT AND REAR SEAT CUSHION CROSSMEMBER

IMPERATIVE : THIS VEHICLE HAS BEEN DESIGNED USING THE MIG BRAZING PROCESS TECHNIQUE ; when the structure is repaired, all the connections concerned must be welded using the same procedure ; any other technique is prohibited .

WARNING : all the scoured areas must be protected by the approved electrolytic re-zincing process .

IMPERATIVE : observe elementary health and safety rules (wearing of filter mask for organic fumes - work in a ventilated area) .

1 - COMPLEMENTARY OPERATION(S)

Removal - refitting :

• FRONT SEATS
• REAR SEAT CUSHION
• side sill trims
• handbrake console
• ventilation duct

Detach - Protect :

• the carpet

2 - IDENTIFICATION OF REPLACEMENT PARTS

(1) Front seat cushion front crossmember assembly .

(2) Front seat rear crossmember assembly .

3 - REPLACEMENT PART COMPOSITION

(3) Front seat front cross member .

(4) Front seat rear crossmember .

(5) Front seat slide mounting nut cage .

(6) Front seat slide mounting nut cage .

4 - PART(S) REQUIRED TO CARRY OUT THE OPERATION

(1) Front seat front cross member .

(2) Front seat rear crossmember .

5 - PREPARATION OF NEW PARTS

6 - CUTTING OUT

7 - RELEASING

8 - ADJUSTMENT

9 - WELDING

10 - PROTECTION