C5HG2XK1 - 307 DW10TD ENGINE DW10ATED ENGINE

REMOVAL - REFITTING ANCILLARY DRIVE BELT

1 - SPECIAL TOOLS

[1] Dynamic roller setting rod (Diameter 4 mm) (-).0188-Q1 .

[2] Dynamic tensioner compression lever (-).0188-Z .

2 - DATA DYNAMIC TENSIONER

(A) Setting hole .

(B) Belt extension checking mark (fixed on engine ) .

(C) Zero extension mark .

(D) Maximum extension mark .

This marking system permits checking of the extension of the belt; if the marks (D) and (B) coincide, it must be replaced .

Tightening of the bolt (1) to 4.5 daN.m .

3 - REMOVAL

IMPERATIVE : if the belt is to be re-used mark the direction of rotation .

Remove :

• the front right-hand wheel
• the protective screen under the power train
• the front right mud shield

Turn the tensioner roller (2) using the tool [2], until the setting rod [1] is located in the setting hole (A) (Pin : Diameter 4 mm) .

Remove the ancillary drive belt .

IMPERATIVE : check that the rollers (2) and (3) turn freely (no play and no tight spots) .

4 - REFITTING

Refit the belt ending with the roller (3) .

IMPERATIVE : take care that the belt is correctly located in the grooves of the various pulleys .

Remove the tool [1] (Using the tool [2]) .

Continue the fitting operations in the reverse order to removal .

Tighten the wheel bolts to 9 da.Nm .