E2AK12F1 - 307

LIFTING

1 - SPECIAL TOOLS

[1] cross beam (-).0010 .

2 - POSITIONING CHASSIS STANDS

2 - 1 - AT THE FRONT

Take the load on the sill with the crossmember as close as possible to the locating plate .

Position the axle stand in the location provided for lifting the vehicle using the jack .

NOTE : to have 2 wheels suspended, repeat the operation on the other side .

2 - 2 - AT THE REAR

Take the load on the sill with the crossmember as close as possible to the locating plate .

Position the axle stand in the location provided for lifting the vehicle using the jack .

NOTE : to have 2 wheels suspended, repeat the operation on the other side .

3 - RAISING FROM ONE SIDE

Position the axle stand in the location provided for lifting the vehicle using the jack .

NOTE : to have 4 wheels suspended, repeat the operation on the other side .

4 - LIFTING ON A 2 POST LIFT

WARNING : removal of units (power unit, rear suspension ...) can cause movement of the centre of gravity : use a single or two post lift fitted with clamps to hold the body to the lift arms .

4 - 1 - WITHOUT BODY SILL TONGS

Place the lift pads on each locating plate (Take care not to damage the plastic screens) .

WARNING : to avoid any risk of the vehicle tilting, removal of mechanical units is prohibited .

4 - 2 - WITH BODY SILL TONGS

WARNING : these clamps are only fitted to lifts of FOG make .

Use only a safety assembly composed of 4 support pads (with pins) .

This assembly replaces the existing pads .

Pull the safety tabs on the outside of the supports before positioning the support pads .

Place the 4 pads under the sill flanges at the locations marked, with the support (B) as close to the flange as possible .

Bring the pads into contact under the take-off points .

Push the 4 safety tabs (A) into the slots provided for the jack .

The vehicle may be lifted .

To release the vehicle, carry out the operation in reverse .