B1BG13K1 - 607 EW12J4 ENGINE

REMOVAL - REFITTING LOWER COVER

1 - REMOVAL

Remove the shield under the power train .

Drain :

• the engine

Remove :

• THE ANCILLARY DRIVE BELT

Disconnect the compressor electrical supply .

Move aside the air conditioning compressor (1) without opening the system .

Disconnect the connector from the power steering circuit pressure sensor .

Move aside the power steering pipe (2) .

Unclip and separate the harness (3) .

Remove the bolt (4) .

Disconnect the pipe (5) .

Remove :

• the 3 bolts (6)

Remove the 2 bolts (7) + The dipstick tube .

IMPERATIVE : remove the exhaust pipe to avoid damaging the flexible hose; this cannot withstand the torsion, traction or bending tensions caused by the removal of one of the power train supports .

Remove the bolt (8) .

Tilt the engine forwards .

Remove :

• the bolts (9) and (10)
• the casing (11)

2 - REFITTING

Clean the seal faces .

Coat the sump gasket surface with a bead of AUTO JOINT OR sealing compound .

Fit the sump (11) .

Fit : The 7 bolts (9) (HM 6 X 110) .

Fit : The 19 bolts (10) (HM 6 X 25) .

Tighten the bolts (9), (10) to 0.1 daN.m .

Fit : The 3 bolts (6) .

Tightening torque : 0.1 da.Nm .

Slacken the bolts (6) .

Tighten the bolts (9), (10) to 0.8 daN.m .

Tighten the bolts (6) to 6 daN.m .

Continue the fitting operations in the reverse order to removal .

Air conditioning compressor tightening torque (1) : 2.5 da.Nm .

IMPERATIVE : always refill with new oil .