B1JG0CK1 - 607 DW12TED4 ENGINE

REMOVAL - REFITTING PARTICLE FILTER

IMPERATIVE : {{n12993}} le remplacement du filtre a particules est une operation necessitant la depose prealable de l'ensemble catalyseur/ filtre a particules .

WARNING : {{n12994}} le respect des specifications decrites dans les gammes est imperatif .

IMPERATIVE : tighten the mounting pin clipping tabs to detach the pin ({{n12995}} risque d'endommagement du flexible decoupleur et des piquages de pression en amont et en aval) .

1 - PACKAGING

IMPERATIVE : do not discard the packaging of the particulate emission filter provided by the parts division .

IMPERATIVE : use this packaging to return the replaced part .

Fit the recovered plugs and closer on the new particulate emission filter at the ends and openings .

Place the particulate emission filter in the recovered bag .

Place everything in the original packaging .

Return the part to the repackaging centre .

2 - REMOVAL

Remove the exhaust hose clip (1) .

Check that there is a white mark on the pipe (A) (if not, mark it) .

Disconnect the pipes (2) .

Remove the sensors (3) (Using a pipe wrench) .

WARNING : do not damage the section (B) of the sensors on removal .

Remove :

• the collar (4)
• the catalytic converter and particle filter assembly, from underneath

WARNING : {{n12996}} faire attention de ne pas blesser le flexible d'echappement, celui-ci ne supporte pas les contraintes en traction, en torsion et en flexion .

Unscrew :

• the pipe (5) (using a pipe wrench)
• the mounting bolts (6) of the pipe (7)

Remove the hose (7) .

Remove the 6 bolts of the clamp (8) .

Remove the particle filter and the seal (9) .

3 - REFITTING

Clean the seal contact surfaces .

IMPERATIVE : {{n12997}} remplacer systematiquement les colliers (1), (4) et le joint (9) .

WARNING : when refitting the seal (9), check the alignment of the curved area (B) which should be aligned with the curved area (C) of the clamp .

Position 2 bolts and nuts (10), (11) without tightening them .

Align the particle filter clamp with that of the catalytic converter .

Position the 4 bolts and nuts at (12), (13), (14), (15) .

Tighten :

• the bolts (in the order indicated from (10) to (15)) to 3.5 da.Nm
• the temperature sensors (3)
• the pipe (5)
• the collars (1), (4) : to 2.5 da.Nm

Do not invert the pressure take-off pipes .

The white paint ring mark (A) corresponds to the downstream pressure take-off of the particulate emission filter .

Continue the fitting operations in the reverse order to removal .

fill the additive reservoir .