B2CJ0YK1 - 607 ML5T GEARBOX
DISMANTLING - ASSEMBLY OUTPUT SHAFT
1 - PRELIMINARY OPERATIONS
Remove :
2 - DISMANTLING
Mount the output shaft (1) in a vice fitted with soft jaws (2) .
Release then remove the output shaft nut (3) .
Remove the gear (4) for 5 th speed .
EXTRACT THE BEARING (5) USING TOOLS [4]-[22] .
Remove :
Remove :
Remove :
WARNING : do not separate the the hub from its sleeve to avoid ejection of the balls and springs .
Remove :
WARNING : do not separate the the hub from its sleeve to avoid ejection of the balls and springs .
Remove :
REMOVE THE STOP RING (19) USING TOOL [6], THICKNESS 2.2 MM .
PRESS OFF THE BEARING (20) USING TOOL [22] .
3 - ASSEMBLY
WARNING : there are 2 possible stop ring thicknesses: 2,25 mm or 3,50 mm .
Fit :
PRESS ON THE BEARING (5) USING TOOL [8] .
Fit the 5 th speed gear (4) .
Tighten the nut (3) to 17 da.Nm .