B3CG0LK1 - 607

REMOVAL - REFITTING FRONT WISHBONE

1 - SPECIAL TOOLS

[1] ball joint extractor (-).0709 .

[2] Lever for uncoupling pivot ball joints (-).0622 .

2 - REMOVAL

Lift and support the vehicle with front wheels suspended .

Remove :

• the wheel
• pivot ball joint securing bolt(s)

Extract the pivot ball joint (Using the tool [1]) .

Detach the swivel ball joint (Using the tool [2]) .

Connect the pivot (1) to the subframe with wire to avoid the transmission becoming dislodged .

Remove : The rear securing bolt (2) .

Remove the wishbone securing bolts (3) .

Remove the wishbone (4) .

3 - REFITTING

Proceed in the reverse order to removal .

Always fit new Nyloc nuts .

Run up the bolts .

Fit the wheel - Tighten to 9 da.Nm .

Place the vehicle at setting height .

Without changing this position, tighten the fastener (6) to 8.5 daN.m .

Without changing this position, tighten the fastener (7) to 4.5 daN.m .

Tighten the nut (8) to 4 da.Nm .

Check and adjust the front suspension geometry .