C4AG0QF1 - 607

REMOVAL - REFITTING BONNET OPENING CABLE

1 - TOOLING

[1] Pliers ( Workshop reference (-).1324-A) .

2 - REMOVAL

Remove the fasteners (2) .

Release the bonnet lock (3) .

Unclip the cable retaining clip (4) .

Remove the cable sleeve retaining clips (5) .

Remove the fasteners (6) .

Remove the lower trim (7) under the steering wheel .

Remove the fasteners (8) .

Detach the built-in systems interface .

Remove the bonnet opening control (10) mounting (11) .

From inside the vehicle, remove the cable (12) and the bulkhead feed-through (13) by pulling .

3 - REFITTING

Proceed in the reverse order to removal .

Use the pliers [1] to position the bulkhead feed-through .

Adjust the position of the bonnet catch .

Tighten the nuts (2) to 0,8 ± 0,2 da.Nm .