C4CG1EK1 - 607

REMOVAL - REFITTING FRONT DOOR LOCK

1 - TOOLING

[1] : chisel ground to an angle of 30 odeg. .

2 - REMOVAL

Remove :

• THE TRIM PAD
• THE LOWER OPENING CONTROL

Detach the sealing sheet at the rear section, Carefully .

Remove the part (1) .

Using the tool [1], cut the rivet heads (2) .

Disconnect the connector (3) .

Remove the burglar-proof cover (4) .

Remove the fasteners (5) .

Remove the burglar-proof cover (6) via the opening (A) .

Remove the fasteners (7) .

Detach the lock assembly (8) via the door inner panel gap .

Remove the locking clip (9) .

Release the bolt (10) from the bracket (11) .

Remove the bolt (10) from its housing .

3 - REFITTING

Position the lock in its location .

IMPERATIVE : retrieve the rivets which have fallen in the base of the door .

Proceed in the reverse order to removal .

IMPERATIVE : if the sealing sheet is torn, replace it .

Check the operation .