C5CG15K1 - 607

REMOVAL/REFITTING OF THE WINDOW WIPER MOTOR

1 - REMOVAL

REMOVE THE SCREEN WIPER MECHANISM .

Position the carrier (1) as shown above .

Remove the motor shaft nut (2) and washer .

Remove the 3 fittings (3) from the motor .

Using a screwdriver blade, lever the carrier (1) to release it from the engine shaft .

Unclip the connector (4) from its bracket .

Remove the wiper motor (5) .

2 - REFITTING

Refit the motor and the 3 fittings (3) of the motor .

Position the carrier (1) between marks (A) and (B) (as shown above) .

Assemble the carrier (1) on the motor shaft .

Fit :

• the washer
• the nut (2)

Refit the wiper mechanism .

Check the operation of the window wiper .

Nut (2) : Tightening torque : 1.8 ± 0.2 da.Nm .

Bolt (3) : Tightening torque : 0.8 ± 0.2 da.Nm .