C5DG0JK1 - 607

REMOVAL - REFITTING JETS/HEADLAMP WASH ASSEMBLY

1 - TOOLING

[1] : Immobilisation fork (Workshop reference C.1349-D) .

2 - REMOVAL

Using a fine blade, detach the jet trim (1) from the bumper skin .

Take hold of the trim and pull it towards you to position the fork [1] in the strut groove, then release it gently .

Using adhesive tape protect the bumper scalloping .

Remove the strut, using pliers .

Using another set of pliers, tighten the 2 clips (2) pulling the jets assembly (1) to unclip it .

Remove the jets assembly (1) and release the strut (3) .

3 - REFITTING

Proceed in the reverse order to removal .

Check the operation .