C5EG0HF1 - 607

REMOVAL - REFITTING REAR HEADLIGHT LEVELLING SENSOR

1 - REMOVAL

Place the vehicle on a lift .

On the rear part of the anti-roll bar :

• disconnect the connector (1)
• using an open-ended spanner, hold the pin (2) and remove the nut (3)
• remove the fastener (4)
• remove the sensor (5) and its bracket

2 - REFITTING

Proceed in the reverse order to removal .

WARNING : if the yoke (5) is removed, it is important to reposition correctly on the flat of the anti-roll bar, which positions the sensor in angular setting .

Initialise and check the headlamp levelling corrector parameter .