E2AK10F1 - 607

LIFTING

1 - SPECIAL TOOLS

[1] cross beam (-).0010 .

2 - LIFTING AT THE FRONT

Position the jack on the stiffener (1) of the subframe between the lower front panel (2) and the crankcase (3) .

3 - RAISING FROM ONE SIDE

3 - 1 - FRONT

IMPERATIVE : use the sill for support with the crossmember [1] by aligning it with the door opening .

Position the stand at the location provided for lifting the vehicle with the jack provided .

3 - 2 - REAR

IMPERATIVE : use the sill for support with the crossmember [1] by aligning it with the door opening .

Position the stand at the location provided for lifting the vehicle with the jack provided .

3 - 3 - FRONT AND REAR

IMPERATIVE : use the sill for support with the crossmember [1] by aligning it with the door opening .

Position the stand at the location provided for lifting the vehicle with the jack provided .

4 - LIFTING ON A 2 POST LIFT

4 - 1 - WITH BODY SILL TONGS

WARNING : removal of units (power unit, rear suspension ...) can cause movement of the centre of gravity ; use a suitable retaining device to make the body integral with the suspension arms .

Position the clamps under the lifting plates with the tightening bolt heads towards the outside of the vehicle .

Place the clamps in the cut-out provided for the jack .

Tighten the clamps using the pin and after tightening insert the pin into the hole (A) .

4 - 2 - WITHOUT BODY SILL TONGS

Place the lift pads on each locating plate .

WARNING : to avoid any risk of the vehicle tilting, removal of mechanical units is prohibited .