C4BH34F1 - 307

REPLACEMENT REAR PANEL AND INNER PANEL ASSEMBLIES

IMPERATIVE : THIS VEHICLE HAS BEEN DESIGNED USING THE MIG BRAZING PROCESS TECHNIQUE ; when the structure is repaired, all the connections concerned must be welded using the same procedure ; any other technique is prohibited .

WARNING : all the scoured areas must be protected by the approved electrolytic re-zincing process .

IMPERATIVE : observe elementary health and safety rules (wearing of filter mask for organic fumes - work in a ventilated area) .

1 - COMPLEMENTARY OPERATION(S)

Replacement :

• REAR BUMPER
• TAILGATE

Removal - refitting :

• TAIL LAMP
• tailgate seal
• tailgate striker

Remove-refit trim :

• rear panel trim
• rear floor
• rear wing inner panels

Detach the electrical harnesses .

2 - IDENTIFICATION OF REPLACEMENT PARTS

Tail panel assembly .

3 - REPLACEMENT PART COMPOSITION

(1) Rear panel .

(2) Tail panel inner panel .

(3) Tailgate striker fixing stiffener .

4 - PART(S) REQUIRED TO CARRY OUT THE OPERATION

Tail panel assembly .

5 - CUTTING OUT

6 - RELEASING

7 - ADJUSTMENT

8 - WELDING

9 - SEALING

10 - PROTECTION