C4CH2CF1 - 307

REPLACEMENT PART EXTERIOR SIDE MEMBER

IMPERATIVE : THIS VEHICLE HAS BEEN DESIGNED USING THE MIG BRAZING PROCESS TECHNIQUE ; when the structure is repaired, all the connections concerned must be welded using the same procedure ; any other technique is prohibited .

WARNING : all the scoured areas must be protected by the approved electrolytic re-zincing process .

IMPERATIVE : observe elementary health and safety rules (wearing of filter mask for organic fumes - work in a ventilated area) .

1 - COMPLEMENTARY OPERATION(S)

Removal - refitting :

• FRONT, REAR DOOR APERTURE SEAL
• FRONT SEAT

Remove-refit trim :

• part front floor

Detach the electrical harnesses .

Protect the front and rear floor .

2 - IDENTIFICATION OF REPLACEMENT PARTS

Outer sill .

3 - PART(S) REQUIRED TO CARRY OUT THE OPERATION

4 - PREPARATION OF THE NEW PART

5 - CUTTING OUT

6 - RELEASING

7 - ADJUSTMENT

8 - WELDING

9 - FINISHING

10 - SEALING

11 - PROTECTION