C5HG3DF1 - 307 DW10TD ENGINE DW10ATED ENGINE

REMOVAL - REFITTING AIR CONDITIONING COMPRESSOR

1 - SPECIAL TOOLS

[1] {{N11950}} kit d'obturateurs de compresseur (-).1701-H .

2 - REMOVAL

{{N11951}} vidanger le fluide frigorigène et le récupérer .

Remove :

• the protective shield under the engine

REMOVE THE ANCILLARY DRIVE BELT .

Remove the nuts (1) .

Disconnect the compressor inlet (2) and outlet (3) unions .

IMPERATIVE : quickly seal the compressor inlets and outlets and the pipes ({{n11952}} a l'aide des obturateurs [1]) .

Remove the 2 bolts (4) .

Disconnect the compressor electrical supply .

Remove :

• the 2 bolts (5)
• the air conditioning compressor (6)

3 - REFITTING

Check that the two split spacers (7) are present .

Check the presence of the two spacers (9) .

WARNING : the anti-rotation nuts (8) secure the compressor (at the rear) .

Refit the compressor in the order of assembly shown above .

Firstly tighten the bolts on the crankshaft pulley side to 4.0 da.Nm then the bolts on the oil filter side to 4.0 da.Nm .

Connect the compressor electrical supply .

IMPERATIVE : reconnect all the connectors fitted with new seals, lubricated with compressor oil .

Tighten the nuts (1) to 2.5 da.Nm .

FIT THE ANCILLARY DRIVE BELT .

Refit the protective shield under the power train .

Charge the refrigerant circuit .