B3FG0JK1 - 607

REMOVAL - REFITTING HANDBRAKE PRIMARY CABLE

1 - REMOVAL

Raise the vehicle .

REPLACE THE SECONDARY BRAKE CABLES .

Lower the vehicle .

4HP20 AUTOMATIC GEARBOX

Place the gear control lever in position N .

ALL MODELS

Using a spatula, unclip the trim (1) .

Raise the armrest (2) .

Using a spatula, unclip the trim (3) .

4HP20 AUTOMATIC GEARBOX

Pull the gear lever panel assembly (3), upwards, to detach it from the console .

Disconnect the connector (4) .

Remove the board (3) .

ALL MODELS

Refit the gaiter without removing the knob .

Remove the bolts (4) .

Raise the plate (5) at the rear .

Unclip then disconnect the connectors (6) .

Disconnect the connector from the cigarette lighter .

Remove the trim at the base of the storage box .

Remove the bolts (8) .

Remove the nut (9) .

Detach the cable (10) from the handbrake lever .

Remove the stop pin (11) .

Release the cable end .

Raise the vehicle .

Pull on the cable (9) then remove it .

NOTE : when removing the cable it is possible that the cable end (12) will become blocked at the opening of the guide tube (13) and prevent removal of the cable .

Two people are required to perform the following operation .

Manually guide the cable under the console, while pulling it from the bottom of the vehicle .

2 - REFITTING

Two people are required to perform the following operation :

• push the cable through the underside of the vehicle
• guide the cable under the console (by lifting the rear of the console)

Refit the stop pin (11) .

Screw in the nut (9) so that X is equal to 2 mm .

2 - 1 - CABLE FREE PLAY

Hook the secondary cables to the primary cable .

Turn the brake force distribution bolt (13) to adjust the tolerance (Pull the cables according to F in order to measure the tolerance Y) .

Pull the handbrake lever 10 times over the whole of its travel .

Continue the fitting operations in the reverse order to removal .

IMPERATIVE : ADJUST THE HANDBRAKE .