B3FG1TK1 - 607
REMOVAL - REFITTING HANDBRAKE SECONDARY CABLES
1 - REMOVAL
Remove the rear wheels .
Completely unscrew the nut (1) while keeping the bolt (2) immobile .
Uncouple the left secondary handbrake cable at (A) .
Remove : Spring clip (3) .
Unclip the cable at (B) .
Pull on the cable cover (4) according to (C) in order for the cable to appear .
Remove the closer using flat nosed pliers .
Position the hole according to the vertical axis (D) .
Slowly turn the disc to the rear (approximately 25 °) until it is possible to find the end of the secondary cable (shake the cable if necessary) .
Push the cable in accordance with (E) .
Push the end (6) of the cable against the locking spring (7) (according to F), using a thin screwdriver .
Pull the cable in the reverse direction from (E) to extract it .
Remove the cable .
2 - REFITTING
Push the end (6) of the cable into its housing until it locks in the separating mechanism (8) of the brake shoes .
Check that the end (6) of the cable is in the correct position .
Continue the fitting operations in the reverse order to removal .
3 - CABLE FREE PLAY
3 - 1 - IN THE EVENT OF ONLY SECONDARY CABLES BEING REPLACED
Screw the nut (1) to obtain play of X = 4 mm (pull the cables according to F to measure the play X) .
Pull the handbrake lever 10 times over the whole of its travel .
IMPERATIVE : ADJUST THE HANDBRAKE .
3 - 2 - IF THE SECONDARY CABLES AND THE PRIMARY CABLE ARE REPLACED