C4AH1GF1 - 607

REPLACEMENT OF COMPLETE FRONT CHASSIS LEG, BASE PLATE FRONT CHASSIS LEG AND WHEEL ARCH REAR PART ASSEMBLY

WARNING : all the scoured areas must be protected by the approved electrolytic re-zincing process .

IMPERATIVE : observe elementary health and safety rules (wearing of filter mask for organic fumes - work in a ventilated area) .

1 - COMPLEMENTARY OPERATION(S)

Replacement :

• front wing
• BONNET
• headlamp bracket
• UPPER FRONT HALF-PANEL

Removal - refitting :

• SCREEN WIPER MECHANISM

Strip-assemble the bulkhead .

Detach :

• front carpet, partly
• electrical harnesses

2 - IDENTIFICATION OF REPLACEMENT PARTS

Wheel arch complete .

Passenger compartment side front stiffener .

3 - REPLACEMENT PART COMPOSITION

(1) Front suspension support stiffener .

(2) Bonnet strut support .

(3) Suspension mounting .

(4) Suspension bracket stiffener .

(5) Front wheel arch .

(6) Front chassis leg .

(7) Front chassis leg stiffener .

(8) Engine sub-frame securing plate .

(9) Engine sub-frame securing bracket .

(10) Engine sub-frame securing stiffener .

(11) Towing eye .

(12) Centre partition .

(13) Front partition .

(14) Web .

(15) Chassis leg upper stiffener .

(16) Rear engine sub-frame tie bar bracket .

(17) Chassis leg front stiffener .

(18) Chassis leg lower stiffener .

(19) Chassis leg front closing panel .

(20) Brake hose bracket .

(21) Lower front half-panel .

(22) Front panel support .

(23) Horn bracket .

(24) Engine sub-frame front mounting support .

(25) Impact absorber support .

(26) Chassis leg link .

(27) Chassis leg link .

4 - PART(S) REQUIRED TO CARRY OUT THE OPERATION

Complete front wheel arch .

Part passenger compartment side front stiffener .

5 - PREPARATION OF THE NEW PART

6 - CUTTING OUT

7 - RELEASING

8 - ADJUSTMENT

9 - WELDING

10 - SEALING

11 - PROTECTION