C5CG13K1 - 607

REMOVAL - REFITTING REAR DOOR WINDOW

1 - REMOVAL

Raise the glass the maximum amount .

REMOVE THE TRIM PANEL .

Detach the sealing film at the top, to access the window fixing (1), and at the bottom to access the lower fixing of the window mechanism .

Release the fastener (1) .

Lower the window using the control on the driver's door (if it does not lower, it must be lowered manually) .

Unclip the fixed window pillar trim (2) .

Remove :

• THE INTERIOR WIPE SEAL (3)
• THE DOOR FRAME INTERIOR TRIM (4)

Using a spatula, remove the external weather strip (5) starting at the side (A) .

Work the window groove seal (6) loose, starting at the top corner .

Pull upwards and remove the front part of the seal .

Remove the door pillar exterior trim mountings (7) .

Detach the trim and let it hang down .

Pull the window upwards to detach it from the door frame .

Remove the glass .

2 - REFITTING

Unscrew the lower fixing of the window rail .

Place the glass on the window without tightening the clamp .

Fit the glass at the top and ensure that it is properly supported at the base of the slide seal; at the top .

Tighten the clamp to the torque: 0,8 ± 0,2 danm .

Lower the window fully .

Tighten the lower fixing of the window rail .

Check the operation .

WARNING : replace the exterior weather strip assembly if it was deformed on removal .

IMPERATIVE : IF THE SEALING SHEET IS TORN, REPLACE IT .

Refit the finisher panel .