C4AH1RF1 - 307

REPLACEMENT UPPER FRONT HALF PANEL ASSEMBLY - ENGINE COMPARTMENT PANEL SUPPORT - CHASSIS LEG END PIECE

IMPERATIVE : THIS VEHICLE HAS BEEN DESIGNED USING THE MIG BRAZING PROCESS TECHNIQUE ; when the structure is repaired, all the connections concerned must be welded using the same procedure ; any other technique is prohibited .

WARNING : all the scoured areas must be protected by the approved electrolytic re-zincing process .

IMPERATIVE : observe elementary health and safety rules (wearing of filter mask for organic fumes - work in a ventilated area) .

1 - COMPLEMENTARY OPERATION(S)

Replacement :

• HEADLIGHT
• FRONT WING
• FRONT BUMPER
• bumper bar

Removal - refitting :

• front panel

Detach the electrical harnesses .

Protect the fuse box .

2 - SPECIAL FEATURES

For adjustment of the half-panel, use the relevant positioning jigs .

3 - IDENTIFICATION OF REPLACEMENT PARTS

(1) Upper front half panel assembly .

(2) Engine compartment panel support .

(3) Chassis leg end piece .

4 - PART(S) REQUIRED TO CARRY OUT THE OPERATION

(1) Upper front half panel assembly .

(2) Engine compartment panel support .

(3) Chassis leg end piece .

5 - PREPARATION OF THE NEW PART

6 - CUTTING OUT

7 - SEPARATING

8 - WELDING