B3DG11K1 - 307
REMOVAL - REFITTING REAR SUSPENSION
1 - SPECIAL TOOLS
[1] Lifting cross piece (-).0007 .
[2] Centring bolt (-).0542 .
2 - REMOVAL
IMPERATIVE : do not lift the vehicle by supporting it under the centre of the rear cross member .
Place the vehicle on a lift .
Slacken the wheel bolts .
Lift and support the vehicle with the rear wheels suspended .
Remove the wheels .
Remove the 2 plastic protectors placed under the vehicle .
Uncouple the wheel sensor harness (1) by means of the connector .
Uncouple the brake hoses (2) and protect the hose holes .
Uncouple the cable (3) from the securing clip .
Uncouple the brakes cables (4) from the brake caliper .
Place a hydraulic stand fitted with the tool [1] under the rear axle .
Remove :
3 - REFITTING
Position the centring bolts [2] on each side of the body .
Offer up the axle under the body so that the yokes are guided by the centring bolts .
Refit the 4 bolts (5) in the unused holes .
Tighten the bolts (5) to 6.2 daN.m .
Replace the bolts [2] with the bolts (5) .
Tighten the bolts (5) to 6.2 daN.m .
Connect the brake pipes (3) .
Fit the harnesses and the hand brake cables .
Fit the wheels .
PLACE THE VEHICLE AT SETTING HEIGHT .
Tighten :