C4BH35F1 - 307 3 DOOR SALOON

REPLACEMENT PART REAR WING

IMPERATIVE : THIS VEHICLE HAS BEEN DESIGNED USING THE MIG BRAZING PROCESS TECHNIQUE ; when the structure is repaired, all the connections concerned must be welded using the same procedure ; any other technique is prohibited .

WARNING : all the scoured areas must be protected by the approved electrolytic re-zincing process .

IMPERATIVE : observe elementary health and safety rules (wearing of filter mask for organic fumes - work in a ventilated area) .

1 - COMPLEMENTARY OPERATION(S)

Removal - refitting :

• REAR BUMPER
• REAR WING LIGHT
• TAILGATE
• quarter light
• mud guard
• BODY WAIST LEVEL PROTECTORS
• front seat belt inertia reel
• tailgate aperture seal
• DOOR APERTURE SEAL
• quarter light seal
• fuel filler flap actuator (right side)
• fuel filler cap (right side)
• FUEL TANK (right side)
• FRONT SEAT
• rear seat cushion
• rear seat backrest

Remove-refit trim :

• rear wing inner panels
• rear pillar

Detach the electrical harnesses .

Protect :

• the front carpet and boot carpet
• front door

IMPERATIVE : ON REFITTING, DO NOT FORGET THE REAR WING DAMPER PLATE .

2 - IDENTIFICATION OF REPLACEMENT PARTS

Rear wing assembly .

3 - REPLACEMENT PART COMPOSITION

(1) Rear wing .

(2) Rear bumper bracket .

4 - PART(S) REQUIRED TO CARRY OUT THE OPERATION

5 - PREPARATION OF THE NEW PART

6 - CUTTING OUT

7 - RELEASING

8 - ADJUSTMENT

9 - WELDING

10 - CRIMPING

11 - FINISHING

12 - SEALING

13 - PROTECTION