C4CH1NF1 - 607

REPLACEMENT OF THE A POST

WARNING : all the scoured areas must be protected by the approved electrolytic re-zincing process .

IMPERATIVE : observe elementary health and safety rules (wearing of filter mask for organic fumes - work in a ventilated area) .

1 - COMPLEMENTARY OPERATION(S)

Replacement :

• front door
• front wing

Removal-fitting :

• WINDSCREEN
• bonnet hinges
• SCREEN WIPER MECHANISM
• connectors
• FASCIA
• DOOR APERTURE SEAL
• FRONT SEAT
• BONNET

Remove-refit trim :

• part front floor
• front pillar
• screen pillar

Detach the electrical harnesses .

2 - IDENTIFICATION OF REPLACEMENT PARTS

Front pillar assembly .

A post inner panel assembly .

Sill front closing panel .

3 - REPLACEMENT PART COMPOSITION

(1) Front pillar .

(2) Dirt excluder seal bracket .

(3) Passenger compartment side front stiffener .

(4) Rear support, screenwash reservoir .

(5) Front pillar inner panel .

(6) Windscreen pillar lining assembly .

(7) Sill insert front stiffener .

(8) Front pillar hinge lower stiffener .

(9) Front post lower spacer .

(10) Front post intermediate spacer .

(11) Door stop yoke stiffener .

(12) Front post upper spacer .

(13) Front pillar hinge upper stiffener .

(14) Post inner panel top stiffener .

(15) Roof bar mounting tapping plate .

(16) Sill front closing panel .

(17) Mud guard bracket .

4 - PART(S) REQUIRED TO CARRY OUT THE OPERATION

Part a post .

Part a post inner panel .

Sill front closing panel .

5 - PREPARATION OF THE NEW PART

6 - CUTTING OUT

7 - RELEASING

8 - ADJUSTMENT

9 - WELDING

10 - FINISHING

11 - SEALING

12 - PROTECTION